Do you only engineer, or also supply the equipment?
Both. Most projects combine design with supply of the specified equipment, so the drawings and the delivered equipment match. Engineering-only scopes are also possible.
Engineering & contracting
Engineering and Contracting Services
Electrical design, panel building, automation, HVAC engineering and turnkey installation, with the equipment supplied by Powersense and the engineering done in-house.
01Overview
Supply and engineering from one team
Powersense supplies equipment and provides the engineering around it. Every discipline below follows the same path of requirements, calculation, drawings, build, verification and handover, documented to IEC and EN standards.
Request a quote →02Disciplines
Engineering disciplines
Each discipline is led by engineers who also specify and supply the equipment, so design, delivery and commissioning stay consistent.
Low-Voltage Switchboards & Control Panels
Low-voltage switchboards and control panels, designed and verified to IEC 61439, built and wired by Powersense with the devices supplied.
View details →
Turnkey Electrical Contracting
Turnkey installation of power, low-current and automation systems, with equipment supplied, verified to IEC 60364-6 and handed over with full documentation.
View details →
Electrical Project Planning & Design
Concept, basic and detailed electrical design supported by calculations, studies and specifications, with the specified equipment supplied by Powersense.
View details →
Industrial & Building Automation (PLC, SCADA)
Control philosophy, PLC and SCADA engineering, instrumentation and drives, with controllers, panels and field devices supplied and commissioned by Powersense.
View details →
HVAC & Smoke-Control Engineering
Heat-load, airflow and smoke-control calculations, CFD simulation, ventilation control and commissioning, with fans and control panels supplied by Powersense.
View details →03Delivery process
From requirements to handover
- 01
Feasibility and requirements
Technical requirements, applicable standards, constraints and a budget range are defined before design starts.
DeliverableDesign brief, scope definition - 02
Calculations and studies
Load, short-circuit, voltage-drop, selectivity and heat-load calculations support each design decision.
DeliverableCalculation reports - 03
Design documents
Single-line diagrams, layouts, schematics, specifications and bills of quantities are prepared for approval and tender.
DeliverableIssued-for-construction drawing set - 04
Procurement and manufacture
Equipment is selected and supplied and, for panels, built and routine-tested by the same team.
DeliverableEquipment schedule, test reports - 05
Installation and commissioning
Installation follows the approved design, and automation is tested before it reaches site.
DeliverableCommissioning records - 06
Verification, handover and maintenance
Systems are verified to IEC 60364-6 and handed over with documentation. Maintenance continues under the same responsibility.
DeliverableAs-built documents, maintenance plan
04Standards
International standards applied
These standards form the technical basis for design and equipment selection. The exact set is confirmed for each project against the national regulations in force.
- IEC 60364-1Low-voltage electrical installations: fundamental principles, assessment of general characteristics and definitions.
- IEC 60909-0Short-circuit currents in three-phase AC systems: calculation of initial, peak and breaking currents.
- IEC 61439-1Low-voltage switchgear and controlgear assemblies: general rules and design verification.
- IEC 60364-6Verification: initial and periodic inspection and testing of electrical installations.
- IEC 61131-3Programmable controllers: programming languages (ladder, function block, structured text, sequential function chart).
- EN 16798-1Energy performance of buildings: indoor environmental input parameters for ventilation design.
05Project types
Typical project types
- Malls and congress centres
- Hospitals and hotels
- Business centres and residences
- Industrial zones and plants
- Infrastructure and utilities
- Renovation and modernisation
06Technical notes
Technical notes and FAQ
Which standards apply in Montenegro?
Projects follow IEC and EN standards together with the national regulations in force. The applicable set is confirmed with the authority and the client at project start.
